Master Spa Twilight Series Manuel du propriétaire Page 72

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 76
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 71
70DO NOT DIVE.
REGULAR MAINTENANCE PROCEDURES
CARE OF YOUR SPA COVER
Always cover your spa when not in use. This will greatly reduce energy consumption and will cause
spa water to heat more rapidly. Water loss and chemical usage will also be reduced.
Be sure to lock down all straps on cover after each use to prevent wind damage.
Do not allow spa to sit uncovered in direct sunlight. This may cause damage to exposed surfaces
of spa and possible discoloration of spa fittings.
Periodically hose off both sides of spa cover for maximum life of cover. Once a month use a vinyl
cleaner and conditioner on the vinyl portion of your cover. Rinse residue off.
Keep cover open for 15 min. after adding chemicals to prevent off gas damage.
NOTE: IF YOUR SPA IS GOING TO BE LEFT EMPTY FOR PROLONGED PERIODS,
DO NOT REPLACE COVER DIRECTLY ON SURFACE OF SPA. PLACE 2”-3” BLOCKS BETWEEN COVER AND
SPA. THIS ALLOWS FOR ADEQUATE
VENTILATION OF COVER AND SPA.
NOTE: The cover warranty is provided through the cover manufacturer and not through Master Spas. You
will need to mail the cover warranty back to the cover manufacturer.
CARE OF YOUR SPA CABINET
Your quality Polymer Skirt simply needs to be hosed off periodically.
No other maintenance is required.
FILTER CLEANING
NOTE: Never operate the spa without filter in place. If done, damage will result
to pumps and other components. We recommend having an extra filter to
install when cleaning the filter.
1.) Turn power off to the spa.
2.) Remove any large or floating debris from the filter area.
3.) Remove the filter. Filter should be periodically rinsed and soaked in a cartridge cleaner. Follow
cartridge cleaner instructions.
4.) Care must be taken not to overtighten the filters when installing them. they only need to be
lightly snugged. Over tightening the filter could cause the threaded portion to become lodged
in the filter bulkhead.
TS 120 and TS 240 Only
Vue de la page 71
1 2 ... 67 68 69 70 71 72 73 74 75 76

Commentaires sur ces manuels

Pas de commentaire